Popular Posts
-
When the error or pop-up message appears on your screen “ink absorber is full”. Your printer needs to reset. Here’s how to fix it! Hardwa...
-
Error Code 6502 appears mostly after changing the cartridge. Option 1 Unplug the printer Remove the faulty Cartridge Plug in the...
-
Now I have not gotten any Samsung ML-1660, but I have method to reset page counter Samsung ML 1660 for you. So that, you must to do this wit...
-
The message Waste ink tank almost full or the error5b00 appears on Canon Pixma iP6220D and Canon Pixma iP6210D. Just reset the was waste in...
-
This is the manual guide of resetting the Canon iP4680 printer. The indication of problem is lights blinking on the POWER and RESUME bu...
-
The waste ink absorber on Canon Pixma mp110 The waste Ink absorber is a small, deep sponge, located where the cartridges rest when the p...
-
Reset Canon Ip1300 The Canon Printer Pixma iP1xxx Series is high quality photo printer at an affordable price. Print borderless photos ...
-
This guide is to reset into factory defaults of the following model Brother DCP-6690CW. Follow the steps below: Make sure the machine ...
-
The SAMSUNG SCX-4300 is small, yet powerful. Despite its diminutive 16.00″ x 14.25″ x 9.10″ dimensions, it cranks out 600 x 600 dpi docum...
-
Samsung ML-1640, a compact and cheep price and suitable for home and small office, has a starter Toner Cartridge can print maximum about 700...
Powered by Blogger.
Previous Post
Thursday, March 28, 2013
Brother HL-1650/1850/1870N Error Code E50 problem solution
Option 1:
Option 2:
Option 1:
- Press the "Go" and "Set" buttons simultaneously while turning on the power.
- Continue to depress the "Go" and "Set" buttons until the LED display shows "Go Test Mode". Release the "Go" and "Set" buttons.
- Depress only the "Go" button again and the printer will start normally.
Option 2:
- Remove the electrical cord from the back of copier.
- Remove bottom tray.
- Remove the smaller tray that comes out the back that has a LTR/A4 lever.
- Open front of machine to take out toner and drum. Leave open.
- Take off top cover (4 screws and two wire jacks to unplug).
- Remove screw on back right side near bottom.
- Remove screw on front left near bottom that holds left side cover.
- Remove screw on back left near bottom (it holds a piece in the back and the side cover).
- Slightly pull out that back, left plastic piece and wiggle things around to get the left side cover off. That back left piece that didn't come out all the way has a plastic tit holding it in. To be able to press that tit is why the side cover is removed. Press tit and pull the back left piece out while wiggling things around to get the 3 plastic pieces in the back to all come out. This exposes the fuser.
- Reomove the two wire jack connections.
- Remove the two screws holding fuser in. One of those screws is big with a spring.
- Find the 2 black wires on the fuser leading to the problem piece. Remove the single screw holding it in.
- Pull it out and clean the wire connections.
Subscribe to:
Post Comments
(Atom)
0 comments:
Post a Comment