Popular Posts
-
When the error or pop-up message appears on your screen “ink absorber is full”. Your printer needs to reset. Here’s how to fix it! Hardwa...
-
Error Code 6502 appears mostly after changing the cartridge. Option 1 Unplug the printer Remove the faulty Cartridge Plug in the...
-
Now I have not gotten any Samsung ML-1660, but I have method to reset page counter Samsung ML 1660 for you. So that, you must to do this wit...
-
The message Waste ink tank almost full or the error5b00 appears on Canon Pixma iP6220D and Canon Pixma iP6210D. Just reset the was waste in...
-
This is the manual guide of resetting the Canon iP4680 printer. The indication of problem is lights blinking on the POWER and RESUME bu...
-
The waste ink absorber on Canon Pixma mp110 The waste Ink absorber is a small, deep sponge, located where the cartridges rest when the p...
-
Reset Canon Ip1300 The Canon Printer Pixma iP1xxx Series is high quality photo printer at an affordable price. Print borderless photos ...
-
This guide is to reset into factory defaults of the following model Brother DCP-6690CW. Follow the steps below: Make sure the machine ...
-
The SAMSUNG SCX-4300 is small, yet powerful. Despite its diminutive 16.00″ x 14.25″ x 9.10″ dimensions, it cranks out 600 x 600 dpi docum...
-
Samsung ML-1640, a compact and cheep price and suitable for home and small office, has a starter Toner Cartridge can print maximum about 700...
Powered by Blogger.
Previous Post
Wednesday, March 6, 2013
If the printer show the error Code E08, means that the ink absorber inside the printer is almost full. To solve this problem, resetting the counter is the solution.
Before doing troubleshooting regarding this printer double check if the power and usb cable are connected and make sure there’s no pending print in the the printer.
Troubleshooting Procedure 1: Hardware Reset
Troubleshooting Procedure 2: Software Reset
Procedure 1: Hardware Reset
- Turn off the printer without pulling the power cords
- Hold down STOP/RESET button and press Power button
- Keep holding down Power button and let STOP/RESET button go
- Then Press STOP/RESET button twice then let BOTH buttons go
- You will notice that the Alternate Blinking error is gone
- Open the program
- Click Reload Button and a new USB port appears
- Load some papers in your printer and press the "Main" Button once, wait until the printing is done
- Press "EEPROM Clear" button to clear EEPROM
- Press EEPROM button and the printer will print some text
- Power off the printer and then turn on again
Subscribe to:
Post Comments
(Atom)
0 comments:
Post a Comment