Popular Posts
-
When the error or pop-up message appears on your screen “ink absorber is full”. Your printer needs to reset. Here’s how to fix it! Hardwa...
-
Error Code 6502 appears mostly after changing the cartridge. Option 1 Unplug the printer Remove the faulty Cartridge Plug in the...
-
Now I have not gotten any Samsung ML-1660, but I have method to reset page counter Samsung ML 1660 for you. So that, you must to do this wit...
-
The message Waste ink tank almost full or the error5b00 appears on Canon Pixma iP6220D and Canon Pixma iP6210D. Just reset the was waste in...
-
This is the manual guide of resetting the Canon iP4680 printer. The indication of problem is lights blinking on the POWER and RESUME bu...
-
The waste ink absorber on Canon Pixma mp110 The waste Ink absorber is a small, deep sponge, located where the cartridges rest when the p...
-
Reset Canon Ip1300 The Canon Printer Pixma iP1xxx Series is high quality photo printer at an affordable price. Print borderless photos ...
-
This guide is to reset into factory defaults of the following model Brother DCP-6690CW. Follow the steps below: Make sure the machine ...
-
The SAMSUNG SCX-4300 is small, yet powerful. Despite its diminutive 16.00″ x 14.25″ x 9.10″ dimensions, it cranks out 600 x 600 dpi docum...
-
Samsung ML-1640, a compact and cheep price and suitable for home and small office, has a starter Toner Cartridge can print maximum about 700...
Powered by Blogger.
Previous Post
Monday, March 11, 2013
When the error or pop-up message appears on your screen “ink absorber is full”. Your printer needs to reset. Here’s how to fix it
Hardware Reset:
Note: Don’t turn off the printer after the hardware reset, just proceed to Software Reset
Software Reset:
Click here to download the iP1880 Resetter
Hardware Reset:
- Unplug the power cable of the printer
- Press and hold down the power button and then plug-in the power cable
- While holding the power button, press the reset/resume button twice and release the power button
- The Alternate Blinking error is gone, this means that the printer is in Service Mode state.
Note: Don’t turn off the printer after the hardware reset, just proceed to Software Reset
Software Reset:
- Extract and open GeneralTool.exe
- Select or Check the EEPROM CLEAR
- Click the MAIN button, you will notice that the power button light will blink. It means that the it clear the waste ink counter
- Unplug the power cable to turn off the printer
- Plug-in the power cable
- Turn ON the printer
Click here to download the iP1880 Resetter
Subscribe to:
Post Comments
(Atom)
0 comments:
Post a Comment