Popular Posts
-
When the error or pop-up message appears on your screen “ink absorber is full”. Your printer needs to reset. Here’s how to fix it! Hardwa...
-
Error Code 6502 appears mostly after changing the cartridge. Option 1 Unplug the printer Remove the faulty Cartridge Plug in the...
-
Now I have not gotten any Samsung ML-1660, but I have method to reset page counter Samsung ML 1660 for you. So that, you must to do this wit...
-
The message Waste ink tank almost full or the error5b00 appears on Canon Pixma iP6220D and Canon Pixma iP6210D. Just reset the was waste in...
-
This is the manual guide of resetting the Canon iP4680 printer. The indication of problem is lights blinking on the POWER and RESUME bu...
-
The waste ink absorber on Canon Pixma mp110 The waste Ink absorber is a small, deep sponge, located where the cartridges rest when the p...
-
Reset Canon Ip1300 The Canon Printer Pixma iP1xxx Series is high quality photo printer at an affordable price. Print borderless photos ...
-
This guide is to reset into factory defaults of the following model Brother DCP-6690CW. Follow the steps below: Make sure the machine ...
-
The SAMSUNG SCX-4300 is small, yet powerful. Despite its diminutive 16.00″ x 14.25″ x 9.10″ dimensions, it cranks out 600 x 600 dpi docum...
-
Samsung ML-1640, a compact and cheep price and suitable for home and small office, has a starter Toner Cartridge can print maximum about 700...
Powered by Blogger.
Previous Post
Wednesday, March 27, 2013
Clean Unable 46 or unable to print clean pad is full appears on your screen monitor. Here’s how to fix it.
This instruction is also applicable to the following model of Epson Printer: Brother DCP 110C, 115C, 120C, 130C, 135C, 145C, 150C, 165C, 185C
This instruction is also applicable to the following model of Epson Printer: Brother DCP 110C, 115C, 120C, 130C, 135C, 145C, 150C, 165C, 185C
- Press the Menu, then Mono Start key
- Press the UP arrow key 4x to make the machine enter the maintenance mode
- "ERROR 46" appears in the display
- Enter maintenance mode 80
- Select 8 by pressing the UP/DOWN arrow key
- Hold OK key and select 0 and push OK key
- Now Press MONO arrow key several times until you see PURGE:XXXXX
- Select 2 and push OK
- Select 7 and push OK
- 8 and push OK
- Select 3 and push OK and the purge counter is now reset to 00000
- Press STOP/EXIT key to go to root of maintenance mode
- Enter code 99 to exit maintenance mode
- Select 9 and push OK
Subscribe to:
Post Comments
(Atom)
0 comments:
Post a Comment